Joints Quad-Ring
Accueil >> Étanchéité >>Joints Toriques >> Joints Quad-Ring Joints Quad-Ring Un double joint à lèvres quatre pour des applications statiques et dynamiques. Quad-Rings (également connu […]
Accueil >> Étanchéité >>Joints Toriques >> Joints Quad-Ring Joints Quad-Ring Un double joint à lèvres quatre pour des applications statiques et dynamiques. Quad-Rings (également connu […]
Accueil >> Étanchéité >>Joints Toriques >> Joints Toriques Moulés Joints Toriques Moulés Le joint torique est un joint simple et versatile qui peut être utilisé
Joints Toriques Moulés Read More »
Accueil >> Étanchéité >>Joints Toriques >> Joints toriques en métal Joints toriques en métal Les joints toriques en métal Daemar sont conçus pour prévenir les
Joints toriques en métal Read More »
Accueil >> Étanchéité >>Joints Toriques >> Programme d’Emballage Programme d’Emballage Les paquets contenant des joints toriques Joints toriques préemballés dans des enveloppes en polyéthylène pour
Joints Toriques Programme d’Emballage Read More »
A complete selection of Inch & Metric sizes of DMR Rotary shaft seals. Available in a range of compounds and a wide selection of oil seal lip styles.
Bearing isolators (Protech seals) are designed to protect bearings with zero lubricant leakage and total exclusion of contaminants.
DMR Bearing Isolators Read More »
A complete selection if JM Cliiper shaft seals in inch and metric shaft sizes. JM Clipper seal sizes ranging from below one inch to well over 40 inches OD.
DMR™ Axle Seals are a unitized, one-piece design, used in environments where outside contamination can damage the sealing lip. Typical applications include axles of trucks, trailers and off-road vehicles.
DMR™ Wheel Hub Seals protect bearings and shafts during operation, installation and removal by providing a built-in wear sleeve and rubber coated metal casings.
V-Rings are all-rubber seals that seat directly on the shaft and seal axially against a counterface, housing, seal case or similar surface.
For gear box applications where the shaft does not pass through the housing wall, end covers are used to seal bearings. Designed to fit into housing bores for rotary shaft lip seals which means that a shaft can easily be left or right-hand oriented. The inner housing is carbon steel and the outer seal is nitrile rubber.
Used in applications where ultra-low friction, chemical compatibility, long life and extreme temperature performance is required.
Teflon Energized Seals Read More »